Good fit if
- You can work a hybrid schedule.
- You can support outages.
Credentials that matter
Skills and tools
- ASME Codes
- NRC Regulations
- 10 CFR
Required qualifications
- in ASME and NBIC R-Stamp Repairs.
- Plant systems integration such as Systems, Programs, or Design Engineering, or other station functional experience.
- Program engineering experience as a SME in ISI and Repair Programs.
- Some positions at PSEG require access to information covered by the Department of Energy’s regulation 10 CFR 810 (Part 810).
- If applicable, the successful applicant must prove they are: (1) a citizen or national of the USA.
- OR (2) a lawful permanent resident of the United States (Non-Conditional Permanent I-551 / Green Card / Permanent Resident Card holder).
- OR (3) a citizen, national, or permanent resident of a "Generally Authorized" destination on the attached list not also a citizen, national, permanent resident of any country not listed.
- OR (4) a "Protected Individual" under the Immigration and Naturalization Act (8 U.S.C 1324b(a)(3)).
About this role
The Corporate Program Engineer (CPE) will be responsible for assigned Program(s) listed in job responsibility below.
Responsibilities
- The Corporate Inservice Inspection (ISI) and Repair / Replacement and Welding Programs is responsible for: Maintaining Corporate ISI Program and Repair Program Procedures and T&RMs, and providing SME review of Station Program Procedures and T&RMs.
- Perform Repair Program implementation by coordinating with the site maintenance staff, AI, and ANII for site activities, including audits.
- Provide engineering review / approval of site and vendor welding procedures, procedure qualification records and welder performance qualifications.
- Maintaining a leadership role in Nuclear Industry Codes and Standards, including membership on industry committees.
- Oversight of ISI activities such as component and structure examinations, examination scheduling, and evaluations.
- Review of published ASME Code Cases for implementation into site programs and procedures as practical.
- Review of site ASME examinations, and evaluations.
- Maintenance of the Welding and Brazing Manual Interfacing with other PSEG Nuclear departments involved with program implementation.
- Job Specific Qualifications BS Degree in Engineering or similar technical degree plus 4 years’ experience with the design, operation, and maintenance of piping, valves, vessels, tanks, and heat exchangers in nuclear power, or a related industry.
- Knowledge of ASME Section IX, ASME Section XI, and the National Board Inspection Code (NBIC).
Location, schedule, and travel
Onsite: Employees work onsite daily.
Pay, eligibility, and equal opportunity
Requisition: 84345 PSEG Company: PSEG Power Salary Range: $ 93,600 - $ 148,200 Work Location Category: Hybrid We’re one of the country’s largest energy companies, with a vision of powering a future where people use energy more efficiently and it’s safer and delivered more reliably than ever.
PSEG is not offering visa sponsorship for this position.
PSEG is an equal opportunity employer, dedicated to a policy of non-discrimination in employment, including the hiring process, based on any legally protected characteristic.
Similar roles
1291B Lead Engineer Nuclear
PSEG